^{1 Voraxor applied at 19.5 – 29 ml/ac (48 – 72 ml/ha) provides rapid burndown control of all weeds listed below.
2 Apply Voraxor at a rate of 41.5 – 57 ml/ac (100 – 140 ml/ha) for suppression of secondary flushes.
3 Suppression only.
4 All types including Roundup Ready®.}

• Avoid application when heavy rain is forecasted.
• Do not apply during periods of dead calm or when winds are gusty.
• Should the product freeze, thaw at room temperature and agitate well before use.

One case of Voraxor herbicide will treat 30 to 80 acres, depending on rate. One case will treat 80 acres for burndown and 30 to 40 acres for residual control.

^{5 Rate restrictions apply. Do not use rate higher than 19.5 ml/ac (48 ml/ha) or injury could result.}

^{6 Rate restrictions apply. Do not use higher than 40.5 ml/ac (100 ml/ha) or injury could result.} 

All applications

Water volume

Mixing order

1. Thoroughly clean the sprayer prior to use by flushing the system with water containing detergent. Refer to previously applied product labels for specific cleaning instructions.
2. Fill the clean spray tank 1/2 full with clean water. Start the agitation system. Agitation should be running during the entire mixing procedure.
3. Add the correct amount of Voraxor and continue to agitate until thoroughly mixed.
4. Prior to adding glyphosate, add the correct amount of herbicide tank mix partner if required.
5. Add in glyphosate.
6. Add the correct amount of Merge adjuvant.
7. Continue agitation while filling the remainder of the tank with water necessary to fill the spray tank.
8. Maintain continuous and constant agitation throughout application until spraying is complete. After any break in spraying, agitate thoroughly before spraying again.
9. Thoroughly clean the sprayer after use by flushing the system with clean water and detergent.

Pre-harvest interval
There is no required pre-harvest interval between a pre-seed or pre-emergent application and harvest. 

3 months after application⁷
Winter wheat

Plant back crops⁸
Barley, chickpeas, faba beans, field corn, dry field peas, lentils, soybeans, wheat (spring, winter, durum) 

Following season⁷
Barley, canola, dry common beans, dry field peas, flax, field corn, lentils, mustard, soybean, wheat (spring, durum) 

^{7 Following a spring application of Voraxor.
8 To be planted in the same season in case of crop failure. Rate restrictions apply. Lentils, field corn and soybeans can only be grown as plant back crops provided that a maximum product rate of 19.5 ml/ac (48 ml/ha) for lentils and 40.5 ml/ac (100 ml/ha) for field corn and soybeans was applied in the previous crop. A second application of Voraxor cannot be made in the rescue crop. Crops can also be planted in the next season following chemfallow treatment applied after August 1.}