Application Tips

• Rates listed above are suggestions only as color variation may occur by crop and based on seed treatments included.
• For most seed treatments, begin at the low rate and evaluate if more product is needed to obtain the desired color.
• When seed treatments contain no color or if a vibrant color is desired, use the high application rate.
• Add additional water to slurry if required based on seed treeatment manufacturer specifications.

Other restrictions & cleanup tips

• Do not apply to food or feed crops or grain after harvest. A spray shield is recommended for applications if over spray or drift is a potential problem.
• Do not discharge into subsoil/soil, drains, surface water and groundwater.
• For small spills, cleanup with absorbent material such as sawdust or general purpose binding agents.
• For large spills, dike the spill and pump out the colorant into labeled containers which should then be sealed.

Seed treatment compatibility

• Always check compatibility of all components in the treatment slurry prior to large scale mixing.

How Much to Apply

One case or tote will treat a varying amount of seed based moisture level.
Consult the table below for the suggested rate information.

Crop		ml per 100 kg of Seed		kg of Seed Treated Per Package Size by Application Rate
				2 x 9.46 L		1 x 984.2 L
		Low Rate	High Rate	Low Rate	High Rate	Low Rate	High Rate
Canola (treated)		ml per 100 kg per Seed Low Rate 32.5	High Rate 65.0	kg of Seed Treated Per Package Size by Application Rate 2 x 9.46 L Low Rate 58,215	High Rate 29,108	1 x 984.2 L Low Rate 3,028,308	High Rate 1,514,154
Canola (5% wt. grain)		ml per 100 kg per Seed Low Rate 13.0	High Rate 78.2	kg of Seed Treated Per Package Size by Application Rate 2 x 9.46 L Low Rate 145,538	High Rate 24,194	1 x 984.2 L Low Rate 7,570,769	High Rate 1,258,568

Directions for use

Prior to use: Shake well or agitate prior to use.

Mixing instructions

1. Start and maintain constant agitation throughout entire mixing and treatment process.
2. Add seed treatment materials per their label instructions followed by Color Coat^™ Colorant and Secompla 67C.
3. Bring the volume of slurry mixture to the desired volume with water.
4. Mix the treatment solution for 10 minutes following the addition of the colorant.